Jump to content
Monthly Subscriptions Are Here Read more... ×

Search the Community

Showing results for tags 'q-sys'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Features Discussion
    • Getting started
    • Release Notes
    • General
    • Feedback & Feature Requests
    • Agent
    • User Portal and Web App
    • Domotz Mobile App
    • Domotz Hardware
  • Third Party Hardware
    • Power Distribution Units (PDU) & Smart Power Plugs
    • Managed Network Switches
    • Gateway/Controller Integrations
    • Wi-Fi Access Point and Controllers Integrations
    • Audio Video and Multimedia Integrations
    • Other Devices
    • Domotz Agents on 3rd party platforms

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Found 1 result

  1. travislpriest

    TCP Tunnel - Q-Sys Designer from remote

    Hello, Here's how to connect to a remote QSC Q-Sys Core via Domotz. These directions and the attached script are based off the Extron from remote thread. I've modified the script to work with the ports Q-Sys uses. Q-Sys Instructions 1. Select the Q-Sys Core from the Domotz WebApp → Device list → Device 2. Go to "Connect" tab 3. Click on "Open a TCP tunnel" 4. Insert the TCP Port. By default you will need to open 3 tunnels for the following ports: 80, 1700 and 6504. 5. Wait to have the tunnel setup 6. Repeat steps 3 and 4 for each port. 7. You will have a host and a port for each TCP Tunnel (see the Extron thread linked at the top for screenshots). 8. Open the .bat file as Administrator (see link below) and enter the requested information on the screen. 9. Add a hard link within Q-Sys Designer following QSC's documentation and use the loopback address you chose (e.g. 127.0.0.100). Note: Make sure the mode is set to HTTP. You should see it turn green. 10. Click OK, then File -> Load from Core & Connect and you should see the Core listed there to connect to. Domotz Q-Sys Connect.bat
×