Kastytis 0 Report post Posted March 6, 2016 Are mPower sockets on the list for integration? https://www.ubnt.com/mfi/mpower/ Quote Share this post Link to post Share on other sites
Silvio 27 Report post Posted March 6, 2016 Ubiquity mPower is going to be supported within few weeks. We will keep the list updated in the section below: http://community.domotz.com/index.php?/forum/19-power-distribution-units-pdu-smart-power-plugs/ Quote Share this post Link to post Share on other sites
Kastytis 0 Report post Posted April 18, 2016 Ubiquity MPower is on the list of supported HW. Great! However I do not see control options on android and web app..Agent version is 1.0.7 on QNAP.. What should I do to make this device controllable (mPower PRO (EU) https://www.ubnt.com/mfi/mpower/ firmware 2.1.11 Quote Share this post Link to post Share on other sites
Giancarlo 33 Report post Posted April 19, 2016 16 hours ago, Kastytis said: Ubiquity MPower is on the list of supported HW. Great! However I do not see control options on android and web app..Agent version is 1.0.7 on QNAP.. What should I do to make this device controllable (mPower PRO (EU) https://www.ubnt.com/mfi/mpower/ firmware 2.1.11 We are investigating in this issue. We should have at least an answer to this case in few hours. Quote Share this post Link to post Share on other sites
Giancarlo 33 Report post Posted April 19, 2016 9 hours ago, Giancarlo said: We are investigating in this issue. We should have at least an answer to this case in few hours. Hi Kastys, there was an issue with our backend, which resulted in not recognizing the Ubiquity MPower when the device is protected by a password. I assume this is your case as well. Can you please check if the device is now recognized as a Power Plug? If so, and the device is password protected, you will be prompted with the request to insert credentials. Just insert the credentials of your Ubiquity MPower and you will unlock the "Config" functionality (you will be able to switch on/off power plugs from within the Domotz App). Let me know if there are further issues. Quote Share this post Link to post Share on other sites
Kastytis 0 Report post Posted April 19, 2016 It recognized smart plug Asked for password to unlock "config" I was unlucky to enter wrong password. I was prompted that "wrong password" Now it unlocked empty config tab .. How I can reenter password? Quote Share this post Link to post Share on other sites
Giancarlo 33 Report post Posted April 19, 2016 you should have the unlock button directly in the config tab. If not, just try to close and reopen the app/webapp and go on that tab again. Quote Share this post Link to post Share on other sites
Kastytis 0 Report post Posted April 19, 2016 Reopened an app and entered right password. Yes!!!!!! Ir works, I've connected plugs with IP devices ..very good. Would you plan to have power cycle option to reboot went down connected IP device? Quote Share this post Link to post Share on other sites
Silvio 27 Report post Posted April 19, 2016 Yes it is in our roadmap. We have a lot of stuff in our queue for the next 3-4 months. But it should come soon after Quote Share this post Link to post Share on other sites
