Jump to content

Archived

This topic is now archived and is closed to further replies.

ddetton

SnapAV Wattbox Power Cycling of Ports

Recommended Posts

ddetton

Wattbox has the capability to power cycle (Reset) a port so that it powers the unit off and then back on again.  This is useful if the router or firewall is plugged into the wattbox because once the unit is powered off, we have lost the ability to get to the Wattbox remotely to power it back on.  It appears that the Domotz UI is not using the Reset function with Wattbox.  Please advise if I am missing something here.  Thanks.

Share this post


Link to post
Share on other sites
Silvio

Yes, we haven't added yet any reboot capability.

There is not a particular reason for this. Our product is very young and we simply haven't found the time yet for this. But we are aiming  to do this pretty soon. Likely by the end of July it is going to be on all PDUs that support this natively.

Share this post


Link to post
Share on other sites
eembee

Hello, just following up on this. Has the Power reset (cycle) function been implemented for Wattbox ? Thanks.

 

>>> Scratch that. Just saw this answered in a different thread: 

 

Share this post


Link to post
Share on other sites
Giancarlo
1 hour ago, eembee said:

Hello, just following up on this. Has the Power reset (cycle) function been implemented for Wattbox ? Thanks.

 

>>> Scratch that. Just saw this answered in a different thread: 

 

 

Simple answer: yes. SnapAP Wattbox driver supports the power cycle (reboot) of single outlets:

 

Screen Shot 2016-11-13 at 8.19.30 PM.png

 

This is true also for other power strips and PDU where the Power Cycle is natively supported by the device itself (e.g. Digital Logger, Panamax, etc).

Share this post


Link to post
Share on other sites

×