TCP Tunnel - Crestron from remote

[Giancarlo 47]

Hi all,

 

This is all the steps to connect from remote to your Crestron controller using Domotz Pro:

Crestron Instruction

1. Select the Crestron Processor device from the Domotz WebApp → Device list → Device
2. Go to "Connect" tab
3. Click on "Open a TCP tunnel"
4. Insert the Crestron Processor TCP Port. (CTP protocol "41795" or SSH port "22" *)
5. Wait to have the tunnel setup
6. You get two informations:

   

   • Host
   • Port
7. Open Crestron Toolbox program on your Laptop and:
   • Open a new project
   • Insert the previously retrieved Host/Port to be inserted here (see attachment as an example)
   • Save & Apply

 

Let us know if you have any problem.

 

*NOTE: The newer firmware versions used the SSH protocol instead of the CTP. So of it is your case just change the protocol to SSH and the port when opening the TCP Tunnel to port 22.