Jump to content

TCP Tunnel - Lutron from remote


Recommended Posts

Hi all,


This is all the steps to connect from remote to your Lutron Processor using Domotz Pro:


Lutron Instruction

  1. Select the Lutron Processor from the Domotz WebApp → Device list → Device
  2. Go in "Connect" tab
  3. Click on "Create a TCP tunnel"
  4. Insert the Lutron Processor TCP Port. By default "51023"
  5. Wait to have the tunnel setup
  6. You get two information:
    • Host
    • Port
  7. Open Lutron Designer program on your Laptop and:
    • Activate -> Processors --> Remote Access form 
    • Insert the previously retrieved Host/Port to be inserted here (see attachment as an example)
    • Save & Apply
  8. Now you can use your Lutron tool to  to remotely access to the processor:

a. Designer+ Tool for Lutron HomeWorks QS:


Screen Shot 2019-10-28 at 10.40.39 AM.png


b. Lutron RadioRA 2 System Overview for Lutron RadioRA:

  • Go to the Find Main Repeater Screen from here in the Design Tab 

     Screen Shot 2019-10-28 at 10.40.58 AM.png

  • And select Advanced, then Remote for System communications as shown here:

 Screen Shot 2019-10-28 at 10.41.16 AM.png

  • He should also have had a previous transfer without the checkbox being selected “Restrict Communications to Local LAN”.


Let us know if you have any problem.


Henrique Salvador

Domotz Support 



image (1).webp

Link to comment
Share on other sites

This topic is now closed to further replies.

  • Create New...